Use and Care

  • 1-The floor dryness should be measured especially in new buildings before starting the installation (floor moisture should be below 40% and room temperature should be below 18 degrees Celsius.)
  • It should be removed from the package when starting the flooring.
  • 2- After the nylon coating on the concrete floor, 2mm mattress or 3mm or 5mm capron should be used to prevent moisture from the bottom. All joints must be glued with broadband.
  • It is recommended to install the parquet towards the direction of light.
  • 3-The laying process should be placed by the wall properly and the female tenon side of the parquet on the wall.

 

When laying the parquet, the expansion walls must be left at the edges of the walls. For a room of normal size, the width should be slightly increased by 15mm, and for larger rooms.


WARNING:

APPLICATIONS THAT MUST BE MADE AFTER THE PARQUET:
The ideal room temperature is 20 degrees Celsius and the relative humidity rate is 50-65%. Depending on the principles of manufacturing, laminated parquet does not undergo any physical changes in the conditions mentioned above.

BUT…

If it is laid in a different temperature and relative humidity than the specified condition, or if it is exposed after laying, it is very likely that cracks will occur in the floor and the floor will rise. In some extreme cases, even under the upper layer can be separated.
In particular, it is of particular importance to check the relative humidity in the room during the cold season (measured or reduced).
Wood is a moisture sensitive material. Especially in new buildings and around the pool, green plant (grass, trees, etc.) due to factors such as moisture formation caused by excessive moisture in the room.

1- MAY EVERY DAY GLOVES MUST BE OPENED OUT OF THE HUMIDITY TO BE PROVIDED OR ANY THERMAL HEATER AND THE HUMIDITY THAT MAY BE INCLUDED.

2- ON THE CARPETS OF CARTRIDGES WITH CARDS FROM THE CARTRIDGES OF CARTRIDGES SHOULD BE CLOSED WITH THE LETTER OF ADHESIVE BAGS.


Otherwise, it will absorb the moisture in the floor (as there is no curtain, carpet, seat, etc.). In this case, uneven fluctuations and deformations will occur in the parquet.
Laminated parquet should not be exposed to direct sunlight. Glasses should be covered with paper or similar materials. Otherwise, in parquets, deformations such as scalding, cracking, dipping and waxing may occur.
For these reasons, users must be aware of the above warnings.

 

AGREE, THE LIABILITY WILL NOT BE ACCEPTED.

MAINTENANCE AND PROTECTION INSTRUCTIONS:

  • 1-For cleaning, wipe with a swab or damp cloth. Use natural alkaline detergent to soften the water and remove stains when fresh.
  • 2-Take precautions under the doors that will cause water leakage and keep away from dust.
  • 3-Put the felt under the furniture legs.
  • 4-Avoid walking with six studded shoes.
  • 5-Always use moisturizer when moisture falls below 40%.